[ Chinese wardrobe net ] I think everyone knows that custom wardrobes are assembled from each part, which seems like a complicated process, but if you understand the specific installation steps and methods, you will find that you don’t need to install the master, you Can also do DIY!
First, the preparation stage
?? 1. Product presence
?? General formal wardrobe brand manufacturers, when the board is shipped to the site, there is generally a good cardboard packaging, after unpacking the package, check whether the pieces of plates and hardware are complete.
??2. fixing screws
?? The nails are generally left in the design according to the design drawings. The workers at the scene will fix the screws with special tools.
?? 3. Measuring side panels
?? Because the wardrobe is placed on the wall, the side panel should be sawn off at the position of the baseboard. After the saw is placed, it should be placed to see if it fits.
Second, the installation phase
??1. Place the bottom plate
The floor placed on the bottom of the wardrobe should be cleaned beforehand, because it will be very troublesome to clean up after installation.
?? 2. Fixed frame
?? Install the groove on the plate to install the side and back panels of the wardrobe, and adjust the direct position of each block.
?? 3. Install the top plate
It is best to prepare a climbing stool on the scene. The top plate should be lifted up and then fixed with rivets.
??4. Install the partition
? Place the partition where you have previously screwed it and then secure it. At this time, pay attention to adjust the fixed position of the partition plate and the back plate and the side plate to prevent the wrong position.
?? 5. Fixed door rail
?? Install the door rail on the top and bottom of the wardrobe. The alloy material selected for the door rail should be better and lighter and firmer.
?? 6. Install the clothes rail
?? Fix the rivets in the reserved position, install the clothes rail, pay attention to balance on both sides.
Third, the finishing stage
??1. Install the door leaf
?? Two sliding doors should be installed in the position of the guide rails. Fix the door leaf first and then fix the guide rails on the bottom side to avoid the phenomenon that the door leaf will fall off later.
?? 2. Adjustment and improvement
After all the installations are completed, make a "full inspection" of the wardrobe. If there is any deviation, adjust it in time.
Fourth, the completion of acceptance
Finally, check the wardrobe: Shake the cabinet to see if it is firm and the details are in place.
Stainless Steel Utensil Holder
Kitchen Steel Cutlery Holder,Steel Utensil Container,Steel Utensil Holder,Steel Flatware Holder
Jiangmen T2grand Stainless Steel Kitchenware Factory , https://www.yapamit.com